1. Change the engine oil. If the transplanter has been used for one season or 50 hours, the engine oil should be changed. You can buy four-stroke gasoline engine oil at a motorcycle parts shop.
2. Clean carburetor, buy cleaning agent in motorcycle parts shop. At the same time disassemble and wash the settling cup. Add fuel and start engine test tools.
3. Check whether the seedling needle and planting fork are deformed and pinched, and if they are deformed, they can be corrected with flat screwdriver. Open the opening of the transplanting fork sled, and the seedling needle sled is straight and parallel, and the gap between the transplanting fork and the seedling needle is about 1mm.
4, check and adjust the main clutch handle wire, transplanting handle wire, lifting handle wire and steering clutch wire clearance and sensitivity, if not sensitive or gap is too large, the adjusting nut will be adjusted. At the same time, drop some oil in these drawline holes to increase flexibility.
5, every day when the work is finished, the machine will be moved to the shore, first rinse the mud on the transplanter with water, and then open back to the garage.
6. As mentioned above, check and correct the shape and gap of seedling needle and planting fork and apply butter. At the same time, apply butter on the upper and lower tracks and on each moving part.
7. Check the engine oil level, fuel tank oil level, hydraulic oil level, insufficient addition.
8. Add appropriate amount of butter and oil mixture in a ratio of 1:1 into the bracket of the inserting part and the rubber plug hole of the inserting arm.
9. When the transplanter is stored, all moving parts and screws and metal parts are coated with butter and rust prevention; Each operation handle is in the off and down position. Drop a few drops on the thread
