1, prohibit the start of the clutch. Should slowly release the clutch pedal, at the same time properly increase the accelerator driving. Otherwise, it will cause impact on the clutch assembly and transmission parts, and even damage.
2. The tractor is strictly prohibited from hanging in neutral or stepping down the clutch to slide downhill.
3, tractor shift and working speed selection. The correct choice of tractor working speed can not only obtain the best productivity and economy, but also prolong the service life of the tractor. Tractor work, should not often overload, to make the engine has a certain power reserve. The field speed of tractor should be selected to make the engine at about 80% load as appropriate.
4. Under normal circumstances, the engine accelerator should be reduced first, then the main clutch pedal should be stepped down, and then the driving brake control pedal should be stepped down gradually, so that the tractor can stop smoothly. In emergency braking, the main clutch pedal and travel brake control pedal should be pressed at the same time. The driver is not allowed to put his foot on the brake pedal or the clutch pedal while traveling. Special reminder: tractor on the road, must be left and right brake pedal interlock. When the tractor stops on the slope, it should be put into gear before releasing the driving brake pedal after the engine is turned off. When going up the slope, it should be put into gear when going down the slope.
5, when the tractor carries out heavy load operation in the field, or works on the wet and soft soil, it usually connects the front drive axle to achieve four-wheel drive operation. The tractor is not allowed to engage the front drive axle for general transportation operations on the hard road, otherwise it will cause early wear of the front wheel.
