When the engine is started, before engaging threshing, cutting table and unloading clutch, the combine harvester should sound the horn to signal before starting, so as to ensure safety.
When the combine harvester is running, hands, feet and other parts of the body are not allowed to touch the moving parts of the machine. All kinds of adjustment and maintenance must be carried out after the engine is turned off.
Check the working reliability of adjusting brake and steering mechanism regularly and solve problems in time.
When unloading grain, it is forbidden to push grain with hands, feet, wooden implements, etc.
When the engine is running, no one is allowed to enter the food tank. If you need to enter the food tank for maintenance, you must turn off the engine and pull out the start key.
Before stopping harvesting, the unit should be run at full throttle for 1-2 minutes to remove residual material in the machine.
When the machine stops working, the gear lever should be placed in neutral position, the clutch of threshing and cutting table should be separated, the hydraulic cylinder should shrink to the non-working position, and then the engine should be shut down.
When repairing the cutting table or having to go to the cutting table or under the bridge for maintenance, the oil cylinder locking device of the cutting table must be locked, otherwise it is strictly prohibited to work under the cutting platform.
When walking on the highway for a long distance, the oil cylinder should also be locked, and the unloading cylinder should be turned back to the transport position and locked firmly.
Often check the power supply connection and insulation, battery line and lap wire can not loose, wire is strictly prohibited short circuit, can not have oil, to prevent fire.
The fire extinguisher equipped with the combine harvester should be placed in the specified position and in good condition.
When refueling, the engine must be turned off. Refueling is not allowed in the harvest field.
When inspecting hydraulic tubing, contact suspected leaks with cardboard or wood. When it is necessary to tighten the tubing joint, the hydraulic cylinder should be in no load state, so as not to hurt the high pressure oil.
Check the spanner, hammer and other tools used to repair the machine after use, so as not to lose in the machine, causing damage to the machine or injury when starting the machine.
Do not go near the straw opening when the combine harvester is working to avoid injury. The machine must be shut down while the blockage is cleared.
When the combine harvester is harvesting or transferring land, people are not allowed outside the cab, and people are not allowed to stand or sit on other parts of the machine.
Driving on the highway to obey the traffic rules, through Bridges, culverts, pay attention to the height, width and load.
