1. The peanut picker must be adjusted and repaired before use. Before operation, the operator should conduct a comprehensive inspection of the fruit picker to see if the fruit picker is in good condition, whether the connecting bolts of each component are tight, whether the pulleys are installed firmly, whether the pulleys are rotated by hand, whether there is collision and friction phenomenon, and the fruit picking part is hobbed Whether there is open welding or missing teeth; turn the hobbing shaft by hand to observe whether the rotation is smooth; check whether the tension of the triangle belt at each transmission part is reasonable; check whether the diesel engine is running well; check whether the motor is running normally and whether the power cord is present Leakage phenomenon. In addition, each rotating part should be equipped with a protective cover; during the trial operation, the staff should leave the fruit picker first, and start the trial operation after the operator sends the specified signal.
2. The operation should be carried out according to the technological process. When feeding peanut seedlings, you must first fill the peanut fruit parts into the feeding port, and the feeding must be uniform; it is strictly forbidden to feed hard objects such as stones, wood, metal objects into the machine during operation to avoid damage to the machine and cause personal accidents; During operation, it is strictly forbidden to reach into the feed inlet, fan port, and exhaust port; during operation, the operator must tighten the sleeves of the clothes, and the female comrades must wear work caps; if abnormal sounds are heard or malfunctions are found during operation, the machine must be shut down for inspection , Timely troubleshooting, strictly prohibit the machine working with diseases; prohibit overloading of the fruit picker; after the end of every day, there must be professionals to check, adjust and maintain. Such as: adding grease, repair welding, etc.; when the fruit picker is blocked, check the feeding amount, dry humidity of the peanut seedlings, tightness of the motor triangle belt, power supply voltage, etc.; adjust the peanut picker when it is not clean The gap between the gear hobbing and the bottom of the screen. The large gap between the hobbing gear and the bottom of the sieve will easily cause unclean picking; when the peanuts contain many impurities and the peanuts are sucked out, the suction port should be adjusted appropriately. Adjust the suction vent down for a long time; when peanuts are sucked out, increase the suction vent.
