1. Start the bundling machine
Check the power output shaft sliding clutch torque before starting the baler. After the baling machine has been maintained and correctly connected to the tractor, it should be confirmed that non-operators have left the machine, the tools have been cleaned, and the power output shaft of the tractor should be carefully engaged, so that the baling machine can operate in no-load state for a period of time.
2. Operation and use
(1) The amount of forage loaded into the baling machine should be consistent. The more consistent each bale is, the more uniform the strips and the more consistent the length of the strips. If the amount of grass loaded is not consistent, it will result in uneven strips of grass.
(2) Bale should be strong enough, requiring bale to stand without deformation. To this end, the pressure slide rail of the baling machine can be tightened as required. If the pressure slide rail is not tight enough, the number of forage blocks in the baling chamber can also be increased. There are holes in the baling chamber, which can be used to install 4 pairs of blocks.
(3) Bale must be dry. If bales are not sufficiently dry, they cannot be transported by baling trailers. Do not leave bundles in the field overnight as they may absorb moisture from the ground and dew.
(4) When baling, use a trailer. After 15-20 bales, stop and wait until the trailer is adjusted and some bales have been picked up. When bales are not found to be as accurate as required, check and eliminate the cause of the poor bales. After it is determined that bales are not suitable for use in the trailer, continue baling but do not put large bales in front of the trailer. Keep the bales as close as possible to the back of the baler.
maintenance
After each use of the baling machine, it is necessary to do a good job of maintenance, cleaning and maintenance, otherwise it is likely to affect its life.
Baling machine and power machinery and equipment, open to the harvested crop, check machinery power contact with baling machine is in good condition, and then start, collecting, baling, after hearing the alarm, parking, step on the gas in the bander baling quickly, and a cord, when heard the sound of the rope severed, forcibly dragged a little rope, baling machine back cover, and make the bale machine, After discharging the straw bale, we can carry out the next straw picking up, so that the cycle is continuous until the work is completed, and then after using it, we should clean it, clean up the impurities like straw in the machine, otherwise it will fail for a long time and affect the normal use.
When cleaning, pay attention not to clean the baling machine with water. After cleaning, the residual water will become the source of accelerated rust and corrosion damage. High pressure gas can effectively remove the residual in the gap and corner of the baling machine; High-speed, high-volume wind generated by gas or electric fans is also an effective way to clean up. However, when cleaning the baling machine with high-pressure gas, it is necessary to wear protective glasses to avoid eye damage.
