1. The installation position of the plow body on the plow frame. Put the plow body in a proper position and fix it with a U-shaped card. After assembly, the tip distance should be 500mm, and the height from the horizontal base of each plow body to the bottom surface of the beam and the design value should not exceed 1%.
2. Clamp the depth-limiting wheel on the longitudinal beam so that the distance between the center of the depth-limiting wheel and the inner side of the front cross beam meets the requirements, and then tighten the nut to fix it.
3. Loosen the bolts on the herringbone frame, thread the rear end of the support rod and the branch seat, the chevron arm and the support with the bolts of the pin shaft respectively, adjust the position, tighten the bolts, and the frame is installed.
4. The tiller width adjuster is fixed on the front beam and consists of 7 holes inside and outside.
