Now is the key period of autumn planting, many farmer friends are in the field using wheat seeder operation, however, wheat seeder often failure, as for wheat seeder failure what, how to troubleshoot? We can keep reading!
Troubleshooting method for wheat seeder
1.seed metering device does not row seed
The main reason is that the transmission gear is not engaged, or the row shaft head row gear square hole wear, adjustment, maintenance or replacement.
2. individual seed metering device does not work
The reason is that the seed rack or seed feeder mouth in individual seed box is blocked by sundries, so clean and seed should be used instead. If the connecting pin between the seed row shaft and individual seed row groove wheel is broken, the pin should be replaced; If the insert board of individual row planting box is not opened, the insert board should be opened.
3. Seed metering device is used for seed metering, but there are no seeds in individual seed groove
The reason is that the ditcher or seed pipe is blocked (mostly in the ditcher on the ground wheel). The blockage should be cleaned up and corresponding measures should be taken to prevent debris from falling into the ditcher.
4.Row seeds, out of control.
The reason is that the separation pin of the clutch brace falls off or the separation gap is too small. The pin should be re-installed and locked, or the separation gap should be adjusted.
5.Row seed intermittently, sowing uneven
The reason is that the transmission gear meshing clearance is too large, the gear skid, should be adjusted; The spring of clutch is too weak, the gear should slip, the spring should be adjusted or replaced.
The above is the wheat seeder troubleshooting method of the relevant introduction, if you want to know more about agricultural information, please continue to pay attention to our website.
