Straw can not be picked up clean possible reasons:
1. Wrong setting of picker (too high off the ground)
2. Driving too fast
3. Spring teeth are broken or worn
Processing:
1, adjust the height of the picker from the ground
2. Slow down
3. Replace a new spring tooth
Reasons for the irregular shape of bales
1, the grass is not uniform, or the feeding fork work rate is not uniform
2. The amount of feeding is too large
3. The height of both sides of the density regulating handle is inconsistent
Processing:
1. Adjust the operation speed and power output shaft speed to make the feeding amount uniform and consistent
2, reduce the speed of operation
3. Adjust the two handles to the same height
Reasons for inconsistent bale lengths
1, tying mechanism clutch clutch claw rotation is not flexible
2. The surface grooves of the pinion of the metering wheel shaft are polished
3. The spring of the actuating arm of the knotter is loose or damaged from the hanging contact
4. Lock nut of metering wheel shaft is loose
Processing:
1. Clean and lubricate clutch clutch claws
2. Replace the pinion and check whether the teeth engraved on the actuating arm of the knotting device meshing with the teeth on the pinion is normal
3, check the spring
4, re-lock the nut
Possible causes of abnormal noise from pick-up structure:
1, spring tooth deformation
2, the drum is broken
3, hay or twine winding
4. The rolling bearing of the turn arm is broken
5. The straw circle is deformed or broken.
Processing:
1. Correct or replace spring teeth
2, replace the drum
3. Remove tangled objects
4. Replace the rolling bearing of the turn arm
5, replace the straw circle
The above is some common problems of the baling machine, I hope to understand the baling machine, can help you
