1. Before the installation of the straw crusher, the site should be smooth, and the conditions can be hardened. To place the equipment smoothly, the installation direction should be determined according to the actual situation of the site and raw materials.
2. Check the circuit and oil circuit to confirm whether the connection is safe. The tightness of each chain, triangle belt and transmission mechanism should be checked frequently in the future use.
3. The blade of the straw crusher is alloy steel products. After a long time of use, if there is wear or change of Angle, the fastening screw of the blade can be loosened, and the blade can be removed for grinding and adjustment.
4. Connect to 380V three-phase power supply from switch box or switch cabinet when connecting to power supply. First check whether there are any debris and branches around the equipment to affect the operation and operation.
5. In the early stage of trial operation, several straight raw materials with a length of about 2-4 meters within the processing range should be selected according to different models of small, medium and large, and the special materials, large diameter and too curved raw materials should be avoided as far as possible.
6. When used to first check the straw crusher host and front-rear system running direction, checking whether the operation of hydraulic system control, flexible cylinder lift is synchronous, freely, hand pump, electric hydraulic pump pressure is within the limits prescribed, accumulator in the oil inlet valve is opened or closed in accordance with the requirements.
7. In the process of operation, attention should be paid to the safety of equipment and people. When the conveying system is running, in addition to the operation of the hydraulic system to adjust the lifting, the wood on the workbench shall not be manually adjusted, so as to avoid the risk of hand injury or wounding.
